Raymarine SmartPilot X-5R manuals
SmartPilot X-5R
Table of contents
- Table Of Contents
- Table Of Contents
- Table Of Contents
- emc conformance
- product disposal
- Chapter 1:Installation and system overviews
- Product documents
- Equipment & Tools
- Tools and equipment NOT supplied
- Chapter 2:Installing the system
- Connections to other equipment
- SPX-5R Drive system Course Computer
- Connection overview
- Step 2 - Check wheel shaft size
- Step 3 - Plan suitable mounting angle
- Step 5- Fit Drive unit
- Fitting to 3/4 inch steering shaft
- Fitting to 1 inch steering shaft
- Drive cable routing
- Connecting power & drive cables to the Course Computer
- Fluxgate Compass
- Mounting procedure
- Pilot Controller
- Connect to ground
- Optional connections
- SeaTalkng power
- NMEA 0183 equipment
- Final checks
- Requirement
- Commissioning
- Step 2 - Check data connections
- Step 4 - Checking steering operating sense
- Align the rudder indicator
- Save the new settings
- Aligning the compass heading
- Aligning rudder bar
- AutoLearn procedure
- Commissioning complete
- Rudder gain
- Counter rudder
- Rudder damping
- Introduction
- Accessing the Calibration modes
- Display calibration
- Setting up data
- User calibration
- Dealer calibration
- Vessel type
- Drive type
- Turn rate limit
- Cruise speed
- System defaults
- NMEA0183 to Course Computer
- Course Computer
- Pilot Controller (ST6002)
- Index
Related products
SmartPilot X5SmartPilot X-5 SportSmartPilot X SeriesSmartPilot X-SeriesSmartPilot SPX-SOLSmartPilot SPX-10SmartPilot ST6002SmartPilot SPX-30SmartPilot SPX-SALSmartPilot SeriesRaymarine categories
Marine Equipment
Monitor
GPS
Marine GPS System
Autopilot System
Fish Finder
Transducer
Radio
Thermal cameras
Marine Radar
manualsdatabase
Your AI-powered manual search engine