Razor E90 Series Owner's Manual

Contents

Razor E90 Series Owner's Manual Manual pdf 4 page image

3aSSEMBLy aND SET-UPq attaching the Handlebarsq Charging the BatteryYour electric scooter may not have a fully charged battery. Therefore it is a good idea to charge the batteryprior to use.2 Turn power OFF beforecharging. Plug the charger intothe charger port on the electricscooter.ChargerChargerPlugChargerPort2 With the front wheel pointedstraight ahead and the handlebarssquare to the front wheel, tightenthe clamp as shown. Tightensecurely.1 Loosen the collar clamp andslide it upward. With a clock-wisetwisting motion, push and “thread”the steering tube onto the fork untilit bottoms out on the fork headsetlock nut.Note: Make sure any cables/wires are out of the way beforeinserting the stem into the fork.WaRNINg: Failureto recharge the battery at leastonce a month may result ina battery that will no longeraccept a charge.WaRNINg: Alwaysdisconnect your scooter fromthe charger before cleaning withliquid.Note: If your charger does notlook like the one illustrated,your unit has been suppliedwith an alternative charger.The specifications and chargingprocedure would not change.The charger has a small windowwith one LED to indicate thecharge status. Refer to theillustration on the charger unitfor the actual “charging” and“charged” status indications foryour model charger.Chargers have built-in over-charge protection to preventbattery from being over-charged.Charger will get warm duringuse. This is normal for somechargers and is no cause forconcern. If your charger doesnot get warm during use, it doesnot mean that it is not workingproperly.q attaching the Handlebar grip WaRNINg: Failure toproperly engage the spring-loadedbutton may cause the handlebarto dislodge while riding and maycause you to lose control andfall. When correctly engaged, thehandlebar will not rotate nor willit move sideways. Note that whenproperly engaged, the spring-loadedbutton is clearly visible in the holeon the T-tube.2 Make certain the spring-loadedbutton engages the hole and isproperly locked into the T-bar.1 Insert and secure the collaps-ible handlebar by pressing thespring-loaded button andinserting it into the T-bar.1 Plug the charger into a walloutlet. If the lights on chargerdo not light up, check the powerto the outlet. If necessary, try adifferent outlet.• Initial charge time: 12 hours• Recharge time: up to 12 hours,even if the light turns green.• Fully charge battery before storing.• When the scooter is not in regular use,recharge the battery at least once amonth until normal use is resumed.• Make sure power is turned OFF whenunit is not in use.• Run time: Up to 40 minutes of continuous ride time.Run time may vary depending on riding conditions,climate and/or proper maintenance.• Constant stopping and starting may shorten ride time.• Average battery life for a poperly maintained unit isapprox. 250 charge/discharge cycles.• To ensure long battery life, never store the product infreezing or below freezing temperatures! Freezing willpermanently damage the battery. Failure to rechargethe battery at least once a month may result in abattery that will no longer accept a charge.• Continue charging for the full 12 hours evenif charge light indicates charging complete.