Razor POWER A 2 Owner's Manual

Also see for POWER A 2: Owner's manual Owner's manual Owner's manual Owner's manual Quick start guide

Contents

Razor POWER A 2 Owner's Manual Manual pdf 7 page image

Tighten the screwsmp to ensure the screw is tightened.Tighten the screws1 23 45ASSEMBLY AND SET-UPAttaching the HandlebarsTool Required: 5 mm Allen Wrench1. Using the 5 mm Allen wrenchloosen the handlebar clamp.5 The tension of the quick-release lever can be adjusted bymanually tightening or loosening the Allen bolt. Be careful notto overtighten. You should always be able to open and closethe quick-release lever by hand and the T-bar should slidefreely when the quick-release is open.2 Insert the handlebar with thethrottle facing the rider.3 Using the 5 mm Allen wrenchtighten the handlebar clamp.4 To adjust the height of the handlebars, open the quick-release lever and slide the T-bar to the desired positionand resecure the quick-release lever to lock into place.WARNING: Failure toproperly secure the quick-releaselever may cause the T-bar totelescope up or down while ridingand may cause you to lose controland fall.Collar ClampWARNING: Failure toproperly tighten the collar clamp mayallow the handlebars to dislodgewhile riding and may cause you tolose control and fall. When correctlytightened, the handlebars will notrotate out of alignment with the frontwheel under normal circumstances.