Regency® E18E Gas Fireplace Insert | 55|safety decalThis is a copy of the label that accompanies each Regency ® Gas Insert. We haveprinted a copy of the contents here for your review. The safety label is located on thefront inside base of the unit visible when the bottom louver is open.Note: Regency ® units are constantly being improved. Check the label on theunit and if there is a difference, the label on the unit is the correct one.Please note that with the addition of thermostat control and outsidecombustion air supply, this unit is approved for bedroom installations.For the State of Massachusetts, installation and repair must be done by a plumberor gasfitter licensed in the Commonwealth of Massachusetts.For the State of Massachusetts, flexible connectors shall not exceed 36 inchesin length.For the State of Massachusetts, the appliances individual manual shut-off mustbe a t-handle type valve.The State of Massachusetts requires the installation of a carbon monoxide alarmin accordance with NFPA 720 and a CO alarm with battery back up in the sameroom where the gas appliance is installed.Part #: 919-789c - Side AColours: Black on white, except for parts indicated as being Red.Punch out .25" hole top right corner where indicated.Size: 100%w- 3.5" x L- 9.5Material: Printable white polyester 7mmAug. 10/17: Created decalc
