Regency Energy U32-NG10 Owners & Installation Manual

Also see for energy U32: Brochure & specs Specification sheet Owners & installation manual

Regency Energy U32-NG10 Owners & Installation Manual Manual pdf 17 page image

U32-10 Regency ® Direct Vent Gas Insert | 17|17installationCONVERSION KIT # 426-969 FROM NG TO LPusing SIT 829 NOVA Gas ValveU32-101 10.28.14919-461Conversion from NG to LP forU32-10 using SIT 829 NOVA Gas ValveTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTERIF IN DOUBT DO NOT DO THIS CONVERSION !!1. Shut off the gas and electrical supply.2. Remove the safety screen and glassdoor - refer to manual for detailed in-structions.3. Remove the logs and embers (if alreadyinstalled).6. Pull off the pilot cap to expose the pilotorifice.Burner OrificeInstallation of LPConversion Kit:4a. Remove the grate by removing thescrews on each side of the grate.Remove the 2 screws,push Burner Tray to the left, and lift off.Remove the 2 screwsholding the grate in position.4b. Remove the Burner Tray by removing thescrews on each side of the tray. Push thetray to the left and lift up.IMPORTANTBefore re-installation of the burner (oncethe LP conversion is complete), theair deflector packed with unit, must beinstalled. See below.WARNING!Also check that the pilot and mainburner injectors are appropriate forthe gas type.5. Install the air deflector to the back wall ofthe firebox using 2 screws.Air Deflector10. Remove NG stepper motor by removing3 screws in locations shown below–re-place with LP stepper motor, secure inplace with 3 screws.Remove NG Stepper motor andreplace with LP Stepper motor11. Check for gas leaks with a proper soapysolution or leak detector.12. Check for proper spark between theignitor and pilot cap. Refer to "LightingProcedure" section of the manual forlighting sequence.13. Check pilot flames. Correct flame patternhas 3 strong blue flames. Adjustmentcan be made by turning the slottedscrew at the top right corner of the valve.Refer to "Maintenance Instructions"section of the manual for correct flamepatterns.14. Check inlet (11" WC min) and outlet (10"WC) pressures. Refer to "Gas Pipe Pres-sure Testing" section of the manual.15. Reverse Steps 5 to 3.16. Attach the label "This unit has been con-verted to LP" near or on top of the serial# decal.17. Replace yellow "NG" label with red "LP"label.18. Check operation of flame control.19. Check for proper flame appearance andglow on logs.8. Remove burner orifice with a 1/2"wrench. Use another wrench to hold onto the elbow behind the orifice. Discardorifice.9. Reinstall new burner orifice LPGstamped #52 and tighten.Each Kit contains one LPConversion KitConversion Kit 426-969 Contains:Qty. Part # Description1 904-390 Burner Orifice #521 904-529 5/32" Allen Key1 918-590 Decal "Convertedto LPG"1 910-582 Stepper Motor1 908-528 Red "LPG" label1 910-037 LPG Injector(Pilot Orifice)1 919-461 Instruction Sheet7. Unscrew the pilot orifice with the allen key;then replace the LP pilot orifice and rein-stall the pilot cap provided in the kit