Regency HZ42STE-NG10 Owners & Installation Manual

Also see for HZ42STE: Owners & installation manual

Contents

Regency Horizon™ HZ42STE-10 Gas Fireplace | 33|MANUFACTURED MOBILE HOME REQUIREMENTSINFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALEThis Regency ® product has been tested and listed by Warnock Hersey/Intertek as a Direct Vent Wall Furnace to the followingstandards: VENTED GAS FIREPLACE HEATERS ANSI Z21.88 - 2014 / CSA 2.33 - 2014 and GAS-FIRED APPLIANCES FORUSE AT HIGH ALTITUDES CAN / CGA 2.17-M91.This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and the ManufacturedHome Construction and Safety Standard, Title 24 CFR, Part 3280, or the current Standard of Fire Safety Criteria for ManufacturedHome Installations, Sites, and Communities ANSI/NFPA 501A, and with CAN/CSA Z240-MH Mobile Home Standard in Canada.This appliance installation must comply with the manufacturer's installation instructions and local codes, if any. In the absence oflocal codes follow the current National Fuel Gas Code, ANSI Z223.1 and the current National Electrical Code ANSI/NFPA 70 in theU.S.A., and the current CAN/CGA B149 Gas Installation Code and the current Canadian Electrical Code CSA C22.1 in Canada.This appliance comes equipped with a dedicated #8 Ground Lug for attachment of the ground wire to the steel chassis as applicableto local codes.The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, withthe National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.This appliance may only be installed in an aftermarket permanently located, manufactured (U.S.A only) or mobile home, where notprohibited by local codes.This appliance can only be used with the type of gas indicated on the rating plate. This appliance is not convertible for use withother gases.Ensure that structural members are not cut or weakened during installation.