40 | Regency Horizon™ HZ42STE-10 Gas Fireplace|40installationOPTIONAL REFLECTIVE PANEL INSTALLATION918-830a 01/05/151HZ42 STOPTIONAL REFLECTIVE PANEL INSTALLATION1) Remove the faceplate and glass door if already installed - seemanual for instructions.Note: Only one glass door needs to be removed - not both.2) Remove the top deflector - located on the inside top of the unit - byremoving 4 screws - as shown below.2) Fit the back panel into position by clearing the pilot shield and fit the3) Loosen screw securing the panel clip located in the middle of theside panel - inside the firebox.The screw is on the top inside of the firebox.6) With panel in position - retighten screw to secure panel clip.7) Repeat steps 3-5 on opposite side.8) Reverse step 2 and 1.4) Orient the panel with the folds facing the wall of the firebox.The thin unfolded edge should be facing down towards the floor ofthe firebox.5) Slide the panel in between the side wall of the firebox and the panelclip - adhere to all handling instructions.Thin edge faces downwardPanel ClipFold facinginThin edgefacingdownBlack Enamel Panels• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.Claims for damage after installation will not receive consideration.• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.* All hand and finger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any finger-prints before applying heat to the unit.Failure to do this will result in burn stain on panels which you will be unable to remove. Not protected by product warranty.