Regency ® L676E Direct Vent Gas Fireplace2To the New Owner:Congratulations!You are the owner of a state-of-the-art Gas Fireplace by REGENCY®. The L676E has beendesigned to provide you with all the warmth and charm of a wood fireplace at the flick of aswitch. The model L676E has been approved by Intertek for both safety and efficiency. Asit also bears our own mark, it promises to provide you with economy, comfort and securityfor many trouble free years to follow. Please take a moment now to acquaint yourself withthese instructions and the many features of your Regency ® Fireplace.MANUFACTURED MOBILE HOME REQUIREMENTSINFORMATION FOR MOBILE/MANUFACTURED HOMES AFTER FIRST SALEThis Regency ® product has been tested and listed by Intertek as a Direct Vent Wall Furnace to the following standards: VENTEDGAS FIREPLACE HEATERS ANSI Z21.88-2005/CSA 2.33-2005, CAN/CGA-2.17-M91, ANSI Z21.50-2003/CSA 2.22-2003,ANSI Z21.50A-2003/CSA 2.22A-2003, ANSI Z21-50B-2003/CSA Z22b-2003 and GAS-FIRED APPLIANCES FOR USE AT HIGHALTITUDES CAN/CGA 2.17-M91.This Direct Vent System Appliance must be installed in accordance with the manufacturer's installation instructions and theManufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, or the current Standard of Fire Safety Criteria forManufactured Home Installations, Sites, and Communities ANSI/NFPA 501A, and with CAN/CSA Z240-MH Mobile Home Standardin Canada.This appliance installation must comply with the manufacturer's installation instructions and local codes, if any. In the absence oflocal codes follow the current National Fuel Gas Code, ANSI Z223.1 and the current National Electrical Code ANSI/NFPA 70 in theU.S.A., and the current CAN/CGA B149 Gas Installation Code and the current Canadian Electrical Code CSA C22.1 in Canada.This appliance comes equipped with a dedicated #8 Ground Lug for attachment of the ground wire to the steel chassis as applicableto local codes.The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, withthe National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.This appliance may only be installed in an aftermarket permanently located, manufactured (U.S.A only) or mobile home, where notprohibited by local codes.This appliance can only be used with the type of gas indicated on the rating plate. This appliance is not convertible for use withother gases, unless a certified kit is used.Ensure that structural members are not cut or weakened during installation.