Regency ® L676E Direct Vent Gas Fireplace 35OPERATIONOPERATING INSTRUCTIONSCOPY OF LIGHTING PLATE INSTRUCTIONSTO TURN OFF GAS APPLIANCEFOR YOUR SAFETY READ BEFORE LIGHTINGLIGHTING INSTRUCTIONSA) BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floorbecause some gas is heavier than air and will settle on the floor.WHAT TO DO IF YOU SMELL GAS- Do not try to light any appliance.- Do not touch any electric switch, do not use any phone in your building.- Immediately call your gas supplier from a neighbours phone. Follow the gas supplier’sinstructions.- If you cannot reach your gas supplier, call the fire department.B) Do not use this appliance if any part has been under water. Immediately call a qualified servicetechnician to inspect the appliance and to replace any part of the control system and any gascontrol which has been under water.C) This appliance needs fresh air for safe operation and must be installed so there are provisions foradequate combustion and ventilation air.CAUTION: Hot while in operation. Do not touch. Severe Burns may result. Dueto high surface temperatures keep children, clothing and furniture, gasoline andother liquids having flammable vapors away. Keep burner and control compartmentclean. See installation and operating instructions accompanying appliance.DO NOT REMOVE THIS INSTRUCTION PLATEWARNING: If you do not follow these instructions exactly, a fire or explosionmay result causing property damage, personal injury or loss of life. Improperinstallation, adjustment, alteration, service or maintenance can cause injuryor property damage. Refer to the owner’s information manual provided withthis appliance. For assistance or additional information consult a qualifiedinstaller, service agency or gas supplier.918-628This appliance must be installed in accordance with local codes, if any;if none, follow the National Fuel Gas Code, ANSI Z223.1/NFPA 54, orNatural Gas and Propane Installation Codes, CSA B149.1.STOP! Read the safety information above on this label.1) Press the ON/OFF button once on the Remote Control.2) If service is to be performed, you must disconnect both sources of powerto the unit; main power and the battery.1) Plug the power cord into a power outlet.2) Press and release the ON/OFF button once on the Remote Control.3) After approximately 3 seconds the spark ignition system will spark for 30seconds to light the main burner.4) If the main burner does not light within 90 seconds, you must reset theunit. See instruction manual for details.