Regency ® L676E Direct Vent Gas Fireplace30INSTALLATIONLOG SET INSTALLATIONInstallation of Interior Brick Panels must be completed before installing the log set.INSTALLATIONRead the instructions below carefully and refer to the diagrams.If the logs are broken do not use the unit until they are replaced.Broken logs can interfere with pilot operation.Log kit (Part No. 521-930 and 521-935) contain the following pieces:a) 03-25 Log Rearb) 03-26 Log Topc) 03-27 Log Front Leftd) 03-28 Log Front Righte) 902-154 Embers Lavaf) 902-179 Vermiculiteg) 946-669 Platinum Embers (supplied with packaged manual)1) Carefully remove the logs from the box and unwrap them. The logsare fragile, handle with care - do not force into position.2) Place log 03-25 on the rear log support pins.The "03" reference numbers (i.e. 03-25) aremolded into the rear of each log.3) Place log 03-27 on the front left side of the burner. Place the rightend of the log into the pin and rest the left end of the log inbetweenthe rear and front burner tubes.03-2803-2603-2703-2503-2503-274) Place the left end of log 03-28 into the pin while resting the right endof the log on the grate. Slide the right end of the log forward until itis approximately 3/8" away from the back side of the grate.03-28RearBurnerTubeFront Burner TubeBackside of Grate5) Line up the two holes on the underside of log 03-26 with the pins onlogs 03-25 and 03-27 and fit in place.03-2603-2703-25