Regency P33S-NG Owners & Installation Manual

Regency P33S-NG Owners & Installation Manual Manual pdf 12 page image

Regency P33 Sunrise TM Gas Fireplace12INSTALLATIONINSTALLATIONBeforeA f t e rBendhereTop Standoff(flat shippingposition)Top Standoffafter bendingThe Top Facing Support, the Side Nailing Stripsand the 2 Top Standoffs must be correctlypositioned and attached to the top before theunit is put into position.Top Standoff AssemblyThe top standoffs are shipped in a flat positionand must be pulled up and bent into the correctshape.1) Remove the standoffs from on top of thefirebox by undoing the screws.2) Take each standoff and bend into the correctshape. Bend up at the bend lines until thescrew holes in the standoff and the pre-punched screw holes on the firebox topline-up.3) Attach the standoffs securely to the top with4 screws per standoff.Note: Secure the standoffs to the holesclosest to the edge of the firebox top.Top Facing Support &Side Nailing StripsDetermine the total thickness of facing material(e.g. drywall, wood plus ceramic tiles) to allowthe finished surface to be flush with the front ofthe unit. Total facing thickness can vary from1/2" (13mm) to 1-1/4" (32mm) thick.The Top Facing Support & Side Nailing Stripscan be mounted in various positions dependingon the thickness of the facing material.1) Mount Top Facing Support using the 3supplied screws into the three pre-punchedscrew holes on the top front of the unit. Adjustsupport to desired facing material depth.2) Mount Side Nailing Strip using the 3supplied screws into the three pre-punchedscrew holes at the front sides of the unit.Adjust support to desired facing materialthickness.UNIT ASSEMBLY PRIOR TO INSTALLATIONSideNailingStripTop FacingSupportVENTING INTRODUCTIONThe P33 Sunrise™ uses the "balanced flue" technology Co-Axial system. The inner liner vents products of combustion to the outside while theouter liner draws outside combustion air into the combustion chamber thereby eliminating the need to use heated room air for combustion and losingwarm room air up the chimney.There are 5 vent systems approved for use with the P33S: the Regency ® Direct Vent Flex System for Horizontal Terminations only and the SimpsonDura-Vent, Selkirk Direct-Temp, Amerivent Direct Vent and Security Secure Vent Systems for Horizontal and Vertical Terminations (see following"Venting" Sections for more details).Note: These fl ue pipes must not be connected to any other appliance.The gas appliance and vent system must be vented directly to the outside of the building, and never be attached to a chimney serving a separatesolid fuel or gas burning appliance. Each direct vent gas appliance must use it's own separate vent system. Common vent systems are prohibited.(See "Rigid Pipe Venting System" for more details and exceptions).NOTE: Ensure compliance with the outside vent terminal location before cutting hole as both dimensions must be met.For a facing material depth of1-1/4"(32mm), the top facingsupport must be reversed.