Regency P33S-NG Owners & Installation Manual

Regency P33S-NG Owners & Installation Manual Manual pdf 38 page image

Regency P33 Sunrise TM Gas Fireplace38INSTALLATIONFACEPLATE INSTALLATIONINSTALLATIONBefore you start:Stainless must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time. Claims for damageafter installation will not receive consideration.To protect the finish during installation and handling - cotton gloves MUST be worn at all times while handling the panels (evenwhen removing protective coating).Stainless will discolor a little during normal operation. This is normal and should not be considered a defect.All hand and finger marks MUST be cleaned off with a soft cloth and a stainless steel cleaner. Most stainless steel cleaners leave afi lm/residue on the surface of the panels. Use an ammonia based cleaner (ie. glass cleaner) to remove this fi lm before applying heat tothe unit. Failure to do this may result in burn stains which you will be unable to remove. This is not a warranty item.1) Install the control shield with 2 #8 - 1/2" Phillips screws to the bottomof the flush door as shown in Diagram 1.3) Loosen 4 phillips head screws located inside firebox, for screw locationssee Diagram 4. Install mounting frame and retighten screws.2) Install the heat deflector on the fi re box as shown in Diagrams 2 &3.Loosen 3 Phillips head screws already in fi rebox, slide heat defl ectoron to screws and retighten.Diagram 4Diagram 3Mounting FrameHeat DeflectorControl ShieldFaceplate SupportDiagram 1P33S Faceplate434-033 Mounting Plate434-514 Faceplate Support434-032 Control Shield434-018F Heat Deflector434-516 Faceplate - Black434-516BL Faceplate - Blue434-516R Faceplate - Red434-517 Faceplate - Stainless SteelDiagram 2Top of Firebox Heat Deflector