Regency P40-LP Owners & Installation Manual

Contents

Regency P40-LP Owners & Installation Manual Manual pdf 27 page image

Regency ® P40-1 Direct Vent Gas Fireplace 27INSTALLATIONINSTALLATIONCONVERSION KIT #502-969 FROM NG TO LPLP Conversion Kit Contains:Qty. Part # Description1 910-462 LP Conversion Coil1 910-037 LP Pilot Orifice1 904-345 Orifice #531 904-575 Orifi ce #551 904-529 Allen Key1 918-590 LP Conversion Decal1 908-528 Red Propane Label1 918-587 Instruction SheetTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTERIF IN DOUBT DO NOT DO THIS CONVERSION !!1) Turn control knob to the OFF position;Shut off the gas supply to the valve;Unplug the power source.2) Remove the louvers and the flush door.3) Remove the logs.4) Remove the Steel Fender, by looseningthe retaining srews on both sides and slid-ing it out of place.5) Remove the front air box by undoing the 3screws.6) Loosen the air shutter adjustment screw andpull out the air shutter adjustment wire.7) Remove the 2 screws on the back burner.8) Slide the burner to the right and lift out.9) Remove the front burner by removing the 2screws. Lift the burner up and swing to theright and slide out.10) Replace the rear burner orifice with #53,using a 1/2" wrench. See image below.Use another wrench to hold onto the elbowbehind the orifice.11) Replace the front burner orifice with #55,using a 1/2" wrench. See image below.Use another wrench to hold onto the elbowbehind the orifice.12) Remove the pilot shield by removing the 2screws.Pilot Shield13) Remove the pilot head from the assemblyusing a flat head screw driver to pop out.Pilot Head14) Remove the NG pilot orifice with the AllenKey and replace with LP pilot orifice. Reat-tach pilot head and clip.Back BurnerFront Air BoxAir ShutterAdjustment WireAir ShutterAdjustment ScrewRear BurnerOrifi ceFront BurnerOrifi ceFront Burner