Regency ® P40-1 Direct Vent Gas Fireplace 31INSTALLATIONINSTALLATIONIMPORTANTDangerous operating conditions mayoccur if the panels are broken.1) Unwrap the Brick Panels from the protective wrapping.2) Ensure that the logs are not in the unit.3) Place the 2 small Back Brick Panels at the base of the firebox onthe left and right side of the burner assembly.Note: Ensure that the full brick pattern is on the bottom and the halfbrick pattern is on top to line up (approximately) with grout lines onside brick panels.4) Insert the Back Brick Panel by slipping it between the back wallof the firebox and the burner assembly, sitting it on the small backbrick panels installed in step 3.Left Side SmallBack Brick PanelRight Side SmallBack Brick Panel5) Remove the Top Brick Panel Bracket by removing the 3 screws.6) Place the Top Brick Panel over the back brick panel and secure withthe top brick panel bracket.7) Remove the screw on the left side of the firebox. Place the left sidebrick panel in position and secure using the brick tab and screw. Repeatfor right side brick panel.Brick TabBack Brick PanelTop Brick PanelBracketTop Brick PanelBrick Panels Completely InstalledBRICK PANEL INSTALLATIONMust install 1 set of brick panels with the P40.