Regency P42-LP3 Owners & Installation Manual

Regency P42-LP3 Owners & Installation Manual Manual pdf 25 page image

Regency P42-3 Zero Clearance Direct Vent Gas Fireplace 25INSTALLATIONDiagram 1Diagram 3STANDARDFLUSH DOORThe standard flush door comes with a blackframe. To install the frame, simply hook the topdoor flange onto the top of the unit and swingthe door towards the unit, diagram 1.Diagram 2NOTE: Springs must always be OVERnot under the gas line.Be careful that the glass gasket does not roll up;there must be a gap between the gasket and thedoor lip to ensure that the door sits securely onthe unit. Diagram 2.Use the hook to pull the spring out until you canput the hook into the slot on the bottom doorbracket. Repeat for 2nd and 3rd spring. Seediagram 3.FLUSH LOUVERS1) Install the top louver by sliding the twobracket clips into the brackets located un-derneath the top of the firebox. Diagram 1.2) Attach the 2 bottom louver hinges to thebottom flange on the firebox using 2 screwsper hinge. Diagram 1.To remove the flush door, reverse the abovesteps.Note: Top and bottom louversare different.Diagram 1Diagram 23) Attach the bottom louver to the 2 hingesusing 2 screws per hinge. Diagram 2.DOUBLE SCREENDOOR1) Pull out the top louver.2) Center the screen door and hook over theflush door.Clip locationsClip installed on right side.3) Open the screen door(s) and secure thescreen door to the flush door front with 2clips on the bottom left and right side.