Regency P42-3 Zero Clearance Direct Vent Gas Fireplace26BAY LOUVERS1) Install top louver by sliding the two bracketclips into the brackets located on top of thebay door. See below. The fitted louverleaves a small gap between faceplatebottom and louver top.Diagram 4Diagram 3Attach 4 supplied magnets each to the back ofthe top and bottom trim pieces, and attach trimto the top and bottom of Bay door. See diagrams3 and 4. 2) Install bottom louver by sliding the twobracket clips into the brackets located un-derneath the bay door. Install bottom louverby sliding the two bracket clips into thebrackets located underneath the bay doorand secure with 1 screw on each end.Note: Top and bottom louvers andbrackets are different.OPTIONAL BAY DOORThe Bay louvers MUST be usedwith the Bay glass option.The optional Bay door is an overlay on theflush front. The standard flush door andglass must remain on the unit.1) Unhook the 2 spring loaded hooks from thebottom of the flush door.2) Hook the top of the bay door over the flushdoor flange and swing the bottom againstthe bottom flange of the flush door.3) Secure to the flush door bottom bracket with2 screws provided.4) Reconnect the 2 spring hooks securing theflush door.5) Slide the valve extension knobs onto thevalve knobs.Note: If any maintenance etc. must bedone in the firebox, first removethe Bay louvers and door.INSTALLATIONOptional Bay Trim