Regency P48-NG2 Owners & Installation Manual

Also see for P48-2: Owners & installation manual

Contents

Regency P48-NG2 Owners & Installation Manual Manual pdf 32 page image

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace 31INSTALLATIONLOG SET INSTALLATIONRead the instructions below carefully and refer to the dia-grams. If logs are broken do not use the unit until they arereplaced. Broken logs can interfere with the pilot opera-tion.The gas log kit (Part # 370-930) contains the following pieces:a) 02-83 Center Cross Logb) 02-84 Right Side Cross Logc) 02-85 Front Left Side Logd) 02-86 Front Right Side Loge) 02-87 Left Side End Logf) 02-88 Rear Logg) 02-89 Middle Right Side Logh) 02-90 Right Side End Logi) 902-154 Embers (Lava)j) 902-179 Vermiculitek) 946-669 Platinum Embers (supplied with packaged manual)1) Carefully remove the logs from the box and unwrapthem. The logs are fragile, handle with care - do notforce into position.3) Line up the two holes on the underside of Log 02-88with the 2 pins at the rear of the grate and positioninto place.4) Place Log 02-85 on the front left side of the burner.Position the right end of the log into the pin on theburner and rest the left end of the log between the 1stgrate post and the front tab.02-8402-8302-8502-8602-8702-9002-89The "02" reference numbers (i.e. 02-83)are molded into the rear of each log.Pins02-8802-85Pin1st Grate Post02-8502-8802-86PinsTab5) Line up the two holes on the underside of Log 02-86with the 2 pins on the right side of the burner and posi-tion into place.02-8802-882) Sprinkle the vermiculite all over the top of the basebrick panel.If you will be installing the optional brick panels, install themprior to installing the logs.