Regency P48-NG2 Owners & Installation Manual

Also see for P48-2: Owners & installation manual

Contents

Regency P48-NG2 Owners & Installation Manual Manual pdf 35 page image

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace34Diagram 1Diagram 3STANDARDFLUSH DOORThe standard flush door comes with a blackframe. To install the frame, simply hook the topdoor flange onto the top of the unit and swingthe door towards the unit, diagram 1.Diagram 2NOTE: Springs must always be OVERnot under the gas line.Be careful that the glass gasket does not roll up;there must be a gap between the gasket and thedoor lip to ensure that the door sits securely onthe unit. Diagram 2.Use the hook to pull the spring out until youcan put the hook into the slot on the bottomdoor bracket. Repeat for 2nd and 3rd spring.See diagram 3.To remove the flush door, reverse the abovesteps.Diagram 1 Diagram 2FLUSH LOUVERS1) Install the top louver by sliding the twobracket clips into the brackets locatedunderneath the top of the firebox.2) Install the bottom louver by folding the louverdown and then sliding the Bottom Louverbracket down onto the 2 pins on the baseof the unit (diagram 1). Secure with 1 screwas per diagram 2.Note: Top andbottom louversare different.3) Open the bottom louver. Pull the BurnerON/OFF control box from inside the bottomof the fireplace. Using the 2 screws on thelouver, secure the control box in place.Burner ON/OFF control box attached tobottom flush louver.Screws onlouver bracketBurner ON/OFFcontrol boxOPTIONAL FLUSH TRIMAttach the round magnets to the back of thetop trim piece and to the bottom trim piece,then attach trim to the top and bottom of Flushdoor.INSTALLATION