Regency P48-NG2 Owners & Installation Manual

Also see for P48-2: Owners & installation manual

Contents

Regency P48-NG2 Owners & Installation Manual Manual pdf 36 page image

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace 35INSTALLATIONBAY LOUVERS1) Install top louver by sliding the two bracketclips into the brackets located on top of thebay door. See below. The fitted louver leavesa small gap between faceplate bottom andlouver top.Diagram 4Diagram 3OPTIONAL BAY TRIMAttach the supplied magnets each to the backof the top and bottom trim pieces, and attachtrim to the top and bottom of Bay door. Seediagrams 3 and 4.Note: Top and bottom louvers andbrackets are different.2) Install bottom louver by sliding the twobracket clips into the brackets locatedunderneath the bay door. Install bottomlouver by sliding the two bracket clips into thebrackets located underneath the bay doorand secure with 1 screw on each end.OPTIONAL BAY DOORThe Bay louvers MUST be usedwith the Bay glass option.The optional Bay door is an overlay on thefl ush front. The standard flush door and glassmust remain on the unit.1) Unhook the 2 spring loaded hooks from thebottom of the flush door.2) Hook the top of the bay door over the flushdoor flange and swing the bottom againstthe bottom flange of the flush door.3) Secure to the flush door bottom bracket with2 screws provided.4) Reconnect the 2 spring hooks securing theflush door.5) Slide the valve extension knobs onto thevalve knobs.Note: If any maintenance etc. must bedone in the fi rebox, fi rst remove theBay louvers and door.Screwson louverbracketBurnerON/OFFcontrol box3) Open the bottom louver. Pull the BurnerON/OFF control box from inside the bottomof the fireplace. Using the 2 screws on thelouver, secure the control box in place.