Regency P48-NG2 Owners & Installation Manual

Also see for P48-2: Owners & installation manual

Contents

Regency P48-NG2 Owners & Installation Manual Manual pdf 5 page image

Regency ® P48-2 Zero Clearance Direct Vent Gas Fireplace4This is a copy of the label that accompanies eachP48-NG2 and P48-LP2 Zero Clearance DirectVent Gas Fireplace. We have printed a copy ofthe contents here for your review. The safetylabel is located on the front inside base of theunit, visible when the bottom louver is open.NOTE: Regency ® units are constantly beingimproved. Check the label on the unit and ifthere is a difference, the label on the unit isthe correct one.SAFETY LABELCOPY OF SAFETY DECALDO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE308308PROPANE:Minimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputAltitudeModel P48-LP2LFPI Fireplace Products International Ltd.Delta, BC, CanadaMinimum Clearances to Combustibles/Degagement MinimumDe Materiaux CombustiblesDUPLICATE SERIAL NO.Serial No./ No de serie918-502aNATURAL GAS:Minimum supply pressureManifold pressure highManifold pressure lowOrifice sizeMinimum inputMaximum inputAltitudeModel P48-NG2L5" (1.25 kPa)3.8" (0.94 kPa)1.1" (0.27 kPa)# 27 DMS29,000 (8.49 Kwh)51,000 (14.94Kwh)0-4500 (0-1372 m)WCWCWCBBft/pitu/htu/hMAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.Model/Modele:P48-NG2 Model/Modele:P48-LP2Listed:Certified for/Certifi e pour:Tested to:WN# 16454CANADA and U.S.A.CGA-2-17-M91, ANSI Z21.88a-2007 / CSA 2.33a-2007VENTED GAS FIREPLACE HEATER / FOYER AU GAZ À ÉVACUATIONéThis appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States, orwhen such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational VehiclesThis appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See owner's manual fordetails.Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur.Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety Standard. Si ces normesne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles.For use with glass doors certified with the appliance onlyMade in Canada/ Fabrique au CanadaThis vented gas fireplace heater is not for use with air filters. Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.Cet appareil doit être utilize uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure si les règlements locauxle permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil ne peut pas être utilisé avec d'autres gaz sauf si une trousse de conversion certifiée est fournie.Pour utilisation uniquement avec les portes en verre certifiées avec l'appareilElectrical supply / Électrique 115VAC, 1.13 A, 60Hz.(See Instruction Manual forDetailed Instructions)DOOR SEAL: Please check that the door is properly sealed12" WC(3.00 kPa)11" WC(2.74 kPa)2.9" WC(0.72 kPa)# 47 DMS26,000 Btu/h (7.61 kW)48,000 Btu/h (14.06 kW)0-4500 ft/pi (0-1372 m)0" Clearance tocombustibles from:Mantel Clearances from Top:Side Wall Clearancefrom Side FacingAlcove Clearances:Minimum Vent Clearances:Top, sides, bottom and rear of unit(A) Min. 8" (203mm)B) 6"Max. Depth 36" (914mm)Min. Width 60" (1524mm),Min. Height 80" (2032mm)Horizontal Top 2-1/2" (64mm)Horizontal SideHorizontal Bottom 1-1/2" (38mm)1-1/2" (38mm)B B39”CeilingWallWallAAPPAREIL FONCTIONNANT AU NATURAL GAZCONCU POUR ETRE POELE:Pression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonl'altitudeCalorifiqueCalorifiqueModéle P48-NG2é é ééééAPPAREIL FONCTIONNANT AU GAZ PROPANECONCU POUR ETRE POELE:Pression d'allimentation minimumPression à la tubulure d' chappement lev ePression à la tubulure d' chappement basseGrandeur de l'injecteurD bit minimum selonD bit maximum selonCalorifiqueCalorifiquel'altitudeModéle P48-LP2é é ééééVENTED GAS FIREPLACE HEATER - NOT FOR USE WITH SOLID FUELS. / NE PAS UTILISER AVEC DUCOMBUSTIBLE SOLIDE.FOYER AU GAZ À ÉVACUATION -For the State of Massachusetts, installationand repair must be done by a plumber orgasfitter licensed in the Commonwealth ofMassachusetts.For the State of Massachusetts, flexibleconnectors shall not exceed 36 inches inlength.For the State of Massachusetts, the appli-ances individual manual shut-off must be at-handle type valve.The State of Massachusetts requires theinstallation of a carbon monoxide alarm inaccordance with NFPA 720 and a CO alarmwith battery back up in the same room wherethe gas appliance is installed.