Regency PG36NG5-R Owner's Installation Manual

Regency ® PG36-5 Gas Log Fireplace32NORMAL OPERATINGSOUNDS OFGAS APPLIANCESIt is possible that you will hear some soundsfrom your gas appliance. This is perfectly normaldue to the fact that there are various gaugesand types of steel used within your appliance.Listed below are some examples. All are normaloperating sounds and should not be consideredas defects in your appliance.Blower:Regency ® gas appliances use high tech blowersto push heated air farther into the room. It is notunusual for the fan to make a "whirring" soundwhen ON. This sound will increase or decreasein volume depending on the speed setting ofyour fan speed control.Burner Tray:The burner tray is positioned directly under theburner tube(s) and logs and is made of a differentgauge material from the rest of the firebox andbody. Therefore, the varying thicknesses of steelwill expand and contract at slightly differentrates which can cause "ticking" and "cracking"sounds. You should also be aware that as thereare temperature changes within the unit thesesounds will likely re-occur. Again, this is normalfor steel fireboxes.Gas Control Valve:As the gas control valve turns ON and OFF, adull clicking sound may be audible, this is normaloperation of a gas regulator or valve.Unit Body/Firebox:Different types and thicknesses of steel willexpand and contract at different rates resultingin some "cracking" and "ticking" sounds will beheard throughout the cycling process.ADJUSTING FLAMEHEIGHTThere are six flame settings that can be adjustedby pressing and releasing the plus (+) and minus(-) FLAME button.The FLAME setting button is located on thecontrol panel in behind the pedestal door.SUMMARY OFCONTROLSOn/Off ButtonIf the unit is switched off, pressing and releasingthis button once will switch the unit on. The unitwill resume its last settings.If the unit is switched on, pressing and releasingthis button once will switch the unit off.Flame:Increase - If the unit is switched on, pressingand releasing the plus (+) button once willincrease the flame height to the next availablehigh setting.Decrease - If the unit is switched on, pressingand releasing the minus (-) button once willdecrease the flame height to the next availablelow setting.Fan:The fan speed is changed by pressing andreleasing the fan button.It operates in 4 modes: OFF, LOW, MEDIUMand HIGH.OPERATING INSTRUCTIONSPILOT ADJUSTMENTPeriodically check the pilot flames. The correctflame pattern has 3 strong blue flames.One flowing around the thermocouple, thesecond flowing across the rear of the burner (itdoes not have to be touching the burner) and thethird flame flowing tangent to the spark ignitor.NOTE: If you have an incorrect flame pattern,contact your Regency ® dealer for furtherinstructions.Rear of BurnerAn incorrect flame pattern will have small,probably yellow flames, not coming intoproper contact with the rear of the burner orthermopile.Rear of Burner