Regency Sunrise P33S-NG4 Owners & Installation Manual

Also see for Sunrise P33S-LP4: Specifications

Contents

10 Regency P33 Sunrise™ Gas FireplaceINSTALLATIONCaution RequirementsThe top, back and sides of the fireplace are defined bystandoffs. The metal ends of the standoff may NOT berecessed into combustible construction.WARNINGFire hazard is an extreme riskif these clearances (air space) to combustible materials are notadhered to. It is of greatest importance that this fi replace and ventsystem be installed only in accordance with these instructions.CLEARANCESThe clearances listed below are Minimum distances unless otherwise stated:A major cause of chimney related fi res is failure to maintain required clearances (air space) to combustible materials. It is of the greatest importancethat this fi replace and vent system be installed only in accordance with these instructions.CFClearance: Dimension Measured From:A: *Front Floor Clearance (min.) 1" (25mm) Underside of UnitB: *Sidewall (on one side) 7-1/2" (241mm) Side of UnitC: *Ceiling(room and/or alcove) 30" (889mm) Top of UnitD: Alcove Width 48" (1219mm) Sidewall to Sidewall (Minimum)E: Alcove Depth 36" (914mm) Front to Back Wall (Maximum)F: Max. mantel depth 12" (305mm)BCClose to CeilingFlue ClearancesHorizontal - Top 2-1/2"Horiztonal - Side 1-1/2"Horiztonal - Bottom 1-1/2"Vertical (Flex Vent) 1-1/2"Vertical (Rigid) 1-1/4"*Note: All measurements are from the top/side of the unit, not optional front.