Regency Sunrise U32SE-NG5 Owners & Installation Manual

U32SE-5 FPI Direct Vent Gas Insert 17INSTALLATIONAn optional AC power adaptor may be installed as a constant power source for the SureFire system.IMPORTANT: Recommend removing the 4-AA batteries in the SureFire receiver.This will avoid battery leakage and power drainage. 4-AA Battery pack may be re-installed into receiver during power outages.NOTE: For all Gas Fireplaces 120 volt power must be brought to the receptacle box inside the ERWWRPRIWKH¿UHER[(provided with the unit).All Freestanding Gas Stoves & Gas Inserts will need a receptacle box located outside / near the unitso that the AC Power Adaptor can be plugged in.INSTALL AC ADAPTOR WITH SUREFIRE WALL RECEIVER SWITCH ONLY - (WITHOUT REMOTE)INSTALL AC ADAPTOR WITH SUREFIRE PROFLAME GT / GTM REMOTE1) Locate “DC Supply” tag on wire harness. For location in unitsee remote installation page in owners manual.2) Connect the male end from AC adaptor to the female endtagged “DC Supply” on wiring harness in unit.2) Locate FCM - COM connector on the Remote wire harness -see manual for location in unit.3) Plug in wire adaptor to FCM - COM connector - be careful notWRGDPDJHHQGV7KLVRQO\¿WVRQHZD\3) Plug AC adaptor into 120V wall outlet (or into 120V receptacle ifLQVWDOOHGLQVLGHWKHJDV¿UHSODFH¿UHER[ 4) Neatly tuck any loose AC Power Adaptor wires neatly underneath /inside the appliance.Note: (QVXUHWKDWZLUHVGRQRWWRXFKWKHXQGHUVLGHRIWKH¿UHER[(keep wires away from the heat as much as possible).FCM - COMAC adaptorwire adaptor1) Connect the male end of the AC adaptor to the female end of thewire adaptor (supplied with AC adaptor) together as shown .AC adaptorWire adaptorFCM - COM4) Plug AC adaptor into 120V wall outlet (or into 120V receptacle ifLQVWDOOHGLQVLGHWKHJDV¿UHSODFH¿UHER[ 5) Neatly tuck any loose AC Power Adaptor wires neatly underneath /inside the appliance.Note: (QVXUHWKDWZLUHVGRQRWWRXFKWKHXQGHUVLGHRIWKH¿UHER[(keep wires away from the heat as much as possible).AC POWER ADAPTOR INSTALLATION (FOR SUREFIRE SYSTEMS)