Serial Communications Page 7-20_________________________________________________________________Command SummaryDescription Page # CommandStop 20 SPurge 21 PTimed Sequence 22 TS {seq name},{point}Manual Sequence 23 MS {seq name},{point}Get Status 24 GS {status types}Error CodesIf error responses are enabled, the Model 2010D may returnthe following error response codes:01 Undefined Command The command was not recognized.02 Check Sum Error The checksum calculated by the2010D did not match the checksumin the command.03 Buffer Overrun Error The calibrator's receive bufferwas overrun because the commandpacket was too long.05 Data Field Error The wrong number of characterswere received.07 Data Error There was an illegal value in acommand parameter field.12 Timeout Error The end of command character() was not received withinthe timeout period.51 Cmd Too Long The command field was too long.52 Addr Too Long The address field was too long.53 Resp Buff Overrun The response data buffer wasoverrun.54 Response Error There was an error calculating aresponse data field.
