Sabio 2010D Operation Manual
Also see for 2010D: Instruction manual
                                                                                                                                                                                      | |
Contents
| 
Section 5 Operation ...................................... 5-1Performing Automatic Calibrations ....................... 5-1Calibrating Multiple Analyzers in One Calibration ....... 5-1Performing Manual Calibrations .......................... 5-2Predefined Operator Stepped Manual Calibration .......... 5-2Timer Stepped Manual Calibration ........................ 5-4Viewing Calibration Status .............................. 5-5Performing Manual Calibrations using the Status Screen 5-7Viewing Diagnostic Information ........................ 5-10The Analog Input Screen ................................. 5-10The Analog Output Screen ............................... 5-11The Internal Control Outputs and User Digital I/O Bits .. 5-11Section 6 Model 2010D Calibration Set-Up .................. 6-1Set Up Gases ............................................ 6-2Set Up Gas Standards ................................... 6-3Diluent and Source Port Assignments .................... 6-4Introduction to Initializing Calibration Sequences ...... 6-6Defining Calibration Sequences .......................... 6-8Setting up Sequence Points for Single-Gas Sequences(Page 2 and 3) .......................................... 6-11Setting up Sequence Points for Multi-Gas Sequences(Page 2 and 5) .......................................... 6-14Auto Calibration Set-up ................................. 6-19Scheduling Automatic Calibrations ....................... 6-20Digital I/O Group Set-up ................................ 6-21Assigning Sequence Start Patterns ....................... 6-24Assigning Point Start Patterns .......................... 6-25Setting the Time and Date ............................... 6-27Section 7 Serial Communications........................... 7-1Operating Modes ........................................ 7-1Prerequisites ........................................... 7-2Configuring the Modem ................................... 7-3Setting Up the Com Ports ................................ 7-4Setting Up the Remote Terminal .......................... 7-6Setting Up the Command Protocol ......................... 7-7Configuring the Computer for Terminal Mode............... 7-9Operating the Model 2010D Remotely using Terminal Mode.... 7-11Disconnecting ........................................... 7-12Operating the Model 2010D Remotely using Command Mode..... 7-13The Monitor Labs Protocol ............................... 7-13Number Representation (Floating Point) .................. 7-14Digital Word Representation ............................. 7-14Command Structure ....................................... 7-15Starting and Ending Commands ............................ 7-15Command Words ........................................... 7-15Calibrator Address ...................................... 7-16Data Fields ............................................. 7-16Data Verification Fields ................................ 7-16 |
Related manuals for Sabio 2010D
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine