Samson 3241 Mounting And Operating Instructions

Also see for 3241: Manual Mounting and operating instructions Mounting and operating instructions Mounting and operating instructions

24 EB 8012 ENPreparation4 PreparationAfter receiving the shipment, proceed as fol-lows:1. Check the scope of delivery. Comparethe shipment received against the deliv-ery note.2. Check the shipment for transportationdamage. Report any damage toSAMSON and the forwarding agent (re-fer to delivery note).4.1 UnpackingNote:Do not remove the packaging untilimmediately before installing thevalve into the pipeline.Proceed as follows to lift and install thevalve:1. Remove the packaging from the valve.2. Dispose of the packaging in accordancewith the valid regulations.NOTICERisk of valve damage due to foreignparticles entering the valve.The protective caps fitted on thevalve's inlet and outlet prevent for-eign particles from entering the valveand damaging it.Do not remove the protective capsuntil immediately before installing thevalve into the pipeline.4.2 Transporting and liftingDANGER!Hazard due to suspended loads fall-ing.Stay clear of suspended or movingloads.WARNING!Risk of lifting equipment tipping andrisk of damage to lifting accessoriesdue to exceeding the rated lifting ca-pacity.− Only use approved lifting equip-ment and accessories whose mini-mum lifting capacity is higher thanthe weight of the valve (includingactuator, if applicable).− Refer to section 3.3 or Data Sheetu T 8012 for weights.WARNING!Risk of personal injury due to controlvalve tipping.− Observe the valve's center of gravi-ty.− Secure the valve against tippingover or turning.