Before Using the Recording and Timeshift Functions" Availability depends on the specific model and area.Before Using the Recording and Schedule Recording Functions● To set up a Schedule Recording, you must first set the TV's clock. Set the Clock (System TimeClock).● You can set up a maximum total of 30 Schedule Viewing and Schedule Recording entries.● Recordings are DRM-protected and therefore cannot be played back on a computer or on adifferent TV. In addition, these files cannot be played back on your TV if its video circuit hasbeen replaced.● A USB hard drive with a speed of 5,400rpm or above is recommended. However, RAID-type USBhard drives are not supported.● USB memory sticks are not supported.● The total recording capacity may vary depending on the amount of available hard drive spaceand the recording quality level.● Schedule Recording requires at least 100MB of free space on the USB storage device. Recordingwill stop if the available storage space falls below 50MB while recording is in progress.● If the available storage space falls below 500MB while both the Schedule Recording and Timeshiftfunctions are in progress, only the recording will stop.● The maximum recording time is 720 minutes.● A video is played according to the TV settings.● If the input signal is changed while recording is in progress, the screen will go blank until thechange is made. In this case, recording will resume, but will not be available.● Device Performance Test must be performed on the USB storage device connected to the TVbefore a recording can be made. To perform the Device Performance Test, select USB Drive inthe MY CONTENT panel and then select the recording device. When you make a recording on theGuide or Programme Info screen, if the USB storage device has failed in the Device PerformanceTest, the Format Device and Device Performance Test are performed again.● When using the Record or Schedule Recording function, the actual recording may start a secondor two later than the specified time.● If the Schedule Recording function is operating while a recording is being made on an HDMI-CECexternal device, the priority is given to the Schedule Recording.● Connecting a recording device to the TV automatically deletes abnormally saved recording files.● If the Off Timer or Auto Power Off has been set, the TV will overide these settings, continue torecord, and turn off after the recording has ended.