Samsung APH523QF Owner's Instructions Manual

Heating Your RoomE-10You must select the Heat mode if you wish to adjust the : Heating temperature Fan speed when heating1 If necessary, press the (On/Off) button.Result: The power indicator on the control panel comes on. The indoor unit beeps.The air conditioner is fitted with a protection mechanism toprevent the unit from being damaged when it is startedimmediately after being: Switched on Stoppedlt will start up normally after three minutes.IMPORTANTIf the is not displayed on the control panel, press the button on theremote control one or more times until it appears.Result: The indoor unit beeps each time you press the button. The air conditioner runs in the Heat mode.2You can change modes at any time.NNNN oooo tttt eeeeYou can't control the airflow direction when the fan doesn't operate.NNNN oooo tttt eeeeTo adjust the temperature, press the buttons on the remote control orbuttons on the control panel one or more times until the required temperature isdisplayed. Possible temperatures are between 16OC and 30OC inclusive.Result: Each time you press the buttons:- The temperature is adjusted by 1OC.- The indoor unit beeps. The air conditioner starts heating, provided that the roomtemperature is lower than the selected temperature. For the first 3~5 minutes, the fan may not operate to preventthe cool air from running out of the indoor unit. If the room temperature reachs the set temperature, the airconditioner stops heating, but the fan is still operating. The Defrost indicator( ) appears when frost forms on the outdoorunit and disappears automatically after removing frost.3Select the fan speed by pressing the button on the remote controlor button one or more times until the required setting is displayed :Result: Each time you press the button, the indoor unit beeps.Automatic(rotated : ➔ ➔ )LowHigh4To control the direction of the air flow, refer to page 16.5