Using Print Materials4.3To load print material in the Multi-purpose Tray:1 Lower the Multi-purpose Tray and unfold the paper supportextension, as shown.2 If you are using paper, flex or fan the edge of the paperstack to separate the pages before loading.3 Load the print material with the print side down.4 Squeeze the paper width guide and slide it to the edge ofthe print material without causing it to bend.If you want to print on previously printed paper from theMulti-purpose Tray, the printed side should be facing upwith the uncurled edge toward the printer. If youexperience problems with the paper feeding, turn thepaper around.N OTE: Make sure that you have not loaded too much printmaterial. The print material buckles if you load a stack that istoo deep or if you push it in too far.5 When you print a document, set the paper source toMulti-Purpose Tray and select the appropriate paper sizeand type in the software application. For details, see theSoftware section.N OTE: After printing, fold awaythe paper support extension andclose the Multi-purpose Tray.Using the Manual FeedYou can manually load a sheet of print material in the Multi-purpose Tray if you select Manual Feed in the Source optionfrom the Paper tab when you change print settings to print adocument. For details about changing print settings, see theSoftware section. Manually loading paper can be helpfulwhen you want to check the print quality after each page isprinted.This loading procedure is almost the same as the procedure forloading in the Multi-purpose Tray, except you load paper sheet-by-sheet in the tray, send print data to print the first page, andpress the On Line/Continue button ( ) on the control panelto print each following page.1 Lower the Multi-purpose Tray and unfold the paper supportextension, as shown.2 Load a sheet of print material with the print side down.
