Samsung CLP-600 Series User Manual

Also see for CLP 600N - Color Laser Printer: User guide Driver manual Driver guide Brochure & specs Parts list

Contents

Using Your Printer on a Network (CLP-600N only)8.313 Repeat step 12 to complete the address from the 1st byteto the 4th byte.14 To select other parameters, such as the Subnet Mask orGateway, press the scroll button ( or ). Press theEnter button ( ).15 Repeat steps 12 through 13 to configure the other TCP/IPparameters.16 Press the On Line/Continue button ( ) to return toready mode.Dynamic Addressing (BOOTP/DHCP)To assign the TCP/IP address automatically by the server, takethe following steps:1 In ready mode, press the Menu button ( ) until you see“Network” on the bottom line of the display. Press theEnter button ( ) to access the menu.2 Press the Enter button ( ) when “Config Network”displays on the bottom line.3 Press the scroll button ( or ) until “Yes” displays,and press the Enter button ( ).4 Press the Upper Level button ( ), then use the scrollbutton ( ).5 Press the Enter button ( ) when “Config TCP” displays.6 Press the scroll button ( or ) until “Yes” displays,and press the Enter button ( ).7 Press the Upper Level button ( ), then use the scrollbutton ( ).8 Press the Enter button ( ) when “IP Get Method”displays.9 Press the scroll button ( or ) until “DHCP” displays,and press the Enter button ( ).10 To assign the address from the BOOTP server, press theEnter button ( ) when “BOOTP” displays.11 Press the On Line/Continue button ( ) to return toready mode.Configuring IPX Frame TypesOn IPX/SPX protocol networks (for example, Novell NetWare),the format of the network communication frames must bespecified for the printer. In most cases, you can keep the ‘Auto’default setting. However, you can manually set the frame typeformat, if required.• Auto (default): Automatically senses and limits the frametype to the first one detected.• EN_8022: Limits the frame type to IPX over IEEE 802.2with IEEE 802.3 frames. All others will be discarded.• EN_8023: Limits the frame type to IPX over IEEE 802.3frames. All others will be discarded.• EN_II: Limits the frame type to IPX over Ethernet Frames.All others will be discarded.• EN_SNAP: Limits the frame type to IPX over SNAP withIEEE 802.3 frames. All others will be discarded.Note that the IPX/SPX protocol must be enabled in theNetware menu before you can configure frame types. See“Setting Network Protocols” on page 8.2.Take the following steps to change the frame type format:1 In ready mode, press the Menu button ( ) until you see“Network” on the bottom line of the display. Press theEnter button ( ) to access the menu.2 Press the Enter button ( ) when “Config Network”displays on the bottom line.3 Press the scroll button ( or ) until “Yes” displays onthe bottom line. Press the Enter button ( ).4 Press the Upper Level button ( ).5 Press the scroll button ( or ) until “Netware”displays on the bottom line. Press the Enter button ( ).6 Press the scroll button ( or ) until “On” displays onthe bottom line. Press the Enter button ( ).7 Press the Upper Level button ( ), then use the scrollbutton ( ).8 Press the Enter button ( ) when “Config Netware”displays.9 Press the scroll button ( or ) until “Yes” displays onthe bottom line. Press the Enter button ( ).10 Press the Upper Level button ( ), then use the scrollbutton ( ).11 Press the Enter button ( ) when “IPX Frame Type”displays.