5.6 <Selecting and loading print media>8 Close the paper cover.9 Slide the tray back into the machine.You can load letterhead with the design side face up. The top edgeof the sheet with the logo should be go into the machine first.After loading paper, set the paper type and size for the tray. Seepage 5.8 for copying and faxing or the Software Section for PC-printing.Note• If there is not enough paper in the tray, load more paper.• If you experience problems with paper feed, place one sheetat a time in the manual feeder.• You can load previously printed paper. The printed sideshould be facing down with an uncurled edge into themachine. If you experience problems with paper feed, turnthe paper around. Note that print quality is not guaranteed.Changing the size of the paper in the trayTo load longer sizes of paper, such as Legal-sized paper, you need toadjust the paper guides to extend the paper tray.To change the tray size to other size, you must adjust the paper lengthguide properly.1 Pull the tray out of the machine. Open the paper cover and removepaper from the tray if necessary.2 Pressing and unlatching the guide lock in the top of the tray, pull thetray out manually.3 Load paper into the tray.4 Slide the paper length guide until it lightly touches the end of thepaper stack. Squeeze the paper width guide and slide it to the edgeof the paper stack without causing it to bend.
