6.5 < Faxing (Optional)>Delaying a fax transmissionYou can set your machine to send a fax at a later time when you will notbe present.1 Press Fax from the Main screen.2 Place the originals face up in the DADF.3 Adjust the document settings in the Image tab and the Basic tab.4 Press the Advanced tab > Delay Send.5 Press On.6 Enter Job Name using the keyboard on the display, select StartTime with left/right arrows.• If you do not enter Job Name, the machine assigns the job nameas 'Fax Send Job xxx'. 'xxx' number are set in order.NoteStart Time is the specific time you want the fax to be sent. Youcan set Start Time on a 24 hour basis and 15 minutes later thanthe current time. For example, if it is 1:00, then you can set thetime starting from 1:15. If the set time is incorrect, the warningmessage will appear and the machine resets it to the currenttime.7 Press OK to start storing the scanned original data into memory.NoteTo cancel delaying a fax, press Off before sending is activated.Sending a priority faxThis function is used when a high priority fax need to be sent ahead ofreserved operations. The original is scanned into memory andimmediately transmitted when the current operation is finished. Inaddition, priority transmission will interrupt a sending to multipledestinations between stations (example, when the transmission to stationA ends, before transmission to station B begins) or between redialattempts.1 Press Fax from the Main screen.2 Place the originals face up in the DADF.3 Adjust the document settings in the Image tab and the Basic tab.4 Press the Advanced tab > Priority Send.5 Press On.6 Press OK.7 Press Start to start the urgent fax job.Sending multiple faxes in a single transmissionYou can send multiple fax jobs in a single transmission.NoteWhen the machine enters power saver mode, the jobs in thesegment list will be deleted to prevent accessing by theunexpected users.1 Press Fax from the Main screen.2 Adjust the document settings in the Image tab and the Basic tab.3 Press the Advanced tab > Job Build.4 Press On to enable the job build function.- Off: Disables Job Build feature.- On: Enables Job Build feature.- Display Between Segments: After executing a segment, the job ispaused with this screen is displayed. Then user can select to keepsending fax or stop.- Delete: Deletes a segment.- Delete All: Deletes all segments.- Send All: Prints all segments.- Add Segment: Adds a new segment.- Cancel: Remove all segments in the list, and cancel the job.5 Press Add Segment.6 Place the originals face up in the DADF.7 Press Start to start scanning a segment for fax job.8 Repeat step 5 to step 7.NoteAs long as space remains on your device's hard drive, you canadd segments without any restriction.9 After adding segments, press Send All
