7CautionLeaking, overheating, or burst batteries could result in fire or injury.Use batteries with the correct specification for the camera.Do not short circuit, heat or dispose of batteries in fire.Do not insert the batteries with the reverse polarities.Remove the batteries when not planning to use the camera for a long period of time.Batteries may leak corrosive electrolyte and irreparably damage the camera's components.Do not fire the flash while it is in contact with hands or objects.Do not touch the flash after using it continuously. It may cause burns.Do not move the camera while it is switched on, if you are using the AC Power Adapter.After use, always switch off the camera before unplugging the adapter from the wall socket.Then make sure that any connector cords or cables to other devices are disconnected beforemoving the camera. Failure to do so may damage the cords or cables and cause a fire orelectric shock.A non-rechargeable (disposable) battery can be used but has a short life span because of itsrelatively low battery capacity. We recommend the rechargeable battery which has a biggercapacity and longer life span than the non rechargeable type. (Rechargeable batteries maynot be available everywhere).An FCC warningThis device has been tested in accordance with the limits of a class B digital deviceunder item 15 of the FCC rules. These limits are designed to provide protectionagainst harmful interference in commercial installation. This equipment generates,absorbs and can emit radio frequency energy. If it is not installed and used inaccordance with the instructions, it may cause harmful interference to radiocommunication.There is however, no guarantee that interference will not occur in some situations.Should any interference occur when this device is in operation, please try one ormore of the following measures.Change the location and direction of any aerial.Increase distance between the camera and the affected device.Use a different socket away from the affected device.Please contact a Samsung agent or a radio/TV engineer.This device complies with part 15 of the FCC Rules.Changes or modifications not expressly approved by the party responsible forcompliance could void user's authority to operate the equipment.