014Connecting to a Power Source Before inserting any cables or the AC adapter, make sure thedirection of the cable or adapter plug is correct. Do not insertby force. It may cause breakage of cable or camera. If the charging LED of the AC Charger does not turn on or blinkafter you have inserted the rechargeable battery, please makesure the battery is inserted correctly. If you charge the battery with the camera power on, the batterywon’t be fully charged. Turn the camera off while charging thebattery to get a full charge.Important information about USB cable usage. Use a USB cable with the correct speci cation. Do not connect the camera to a PC through a USB hub.Connect the camera directly to the PC. Do not connect the camera and other devices to a PC at thesame time. Connect the camera by itself. If your PC can not detect the camera when you use the frontside USB port, use the back side USB port of computer. If the USB port of the PC doesn’t meet the Power output standard(5V, 500mA), the battery may not charge. Charging LED of the AC chargerCharging LEDBeing Charged Red LED is onCharging is complete Green LED is onCharging error Orange LED is off or blinking If you insert a fully discharged battery to charge it, do not turn onthe camera at the same time. The camera must not be turned onbecause of the low battery capacity. Charge the battery for morethan 10 minutes before using the camera. Do not use the flash frequently or take a movie clip with the fullydischarged battery charged only for a short time. Even if thecharger is inserted, the camera power may turn off because therechargeable battery has discharged again. How to charge the rechargeable battery