78System RequirementsFor Windows For MacintoshPC with processor better thanPentium II 450MHz(Pentium 800MHz recommended)Power Mac G3 or laterWindows 98SE/2000/ME/XP/Vista Mac OS 10.0 ~ 10.4Minimum 128MB RAM(Over 512MB recommended)200MB of available hard disk space(Over 1GB recommend)Minimum 64MB RAM110MB of available hard-disk spaceUSB port USB portCD-ROM drive CD-ROM drive1024x768 pixels, 16bit color displaycompatible monitor(24bit color display recommended)MicroSoft DirectX 9.0CMPlayer (For movie)About the softwareAfter inserting the CD-ROM provided with this camera into the CD-ROMdrive, the following window should automatically run.Before connecting the camera to the PC,you should first install the camera driver.Camera driver : This enables images to transfer between the camera andPC.This camera uses the USB Storage Driver as the camera driver. Youcan use the camera as a USB card reader. After installing the driverand connecting this camera to the PC, you can find [Removable Disk]in [Windows Explorer] or [My computer]. A USB Storage Driver isprovided only for Windows. A USB Driver for MAC is not included with theApplication CD. You can use the camera with Mac OS 10.0~10.4.XviD codec : This allows movie clips (MPEG-4) recorded with this camerato be played back on a PC.To play back a movie clip recorded with this camera, you must install theXviD codec. If a movie clip recorded with this camera does not play well,install this codec. This software is only compatible with Windows.
