operating _1302 OPERATINGRecommend Temp (Freezer) : -2°F (or -19°C )minimum of 40 to 60 psi (276 to 414 kPa.)If the water pressure to the reverse osmosis system isless than 40 to 60 psi (276 to 414 kPa):• Check to see whether the sediment filter in thereverse osmosis system is blocked. Replace thefilter if necessary.• Allow the storage tank on the reverse osmosissystem to refill after heavy usage.• If your refrigerator has a water filter, it may furtherreduce the water pressure when used in conjunctionwith a reverse osmosis system. Remove the water filter.If you have questions about your water pressure, calla licensed, qualified plumber.CONTROLLING THE TEMPERATuREBasic temperature of Freezer andRefrigerator CompartmentsThe basic temperature and recommendedtemperatures of the Freezer and RefrigeratorCompartments are -2°F and 38°F (or -19°C and 3°C)respectively. If the temperature of the Freezer andRefrigerator Compartments are too high or low, adjustthe temperature manually.Controlling the Freezer temperatureThe Freezer temperature can be set between -8°Fand 8°F (or between -22°C and -14°C) to suit yourparticular needs. Press the Freezer button repeatedlyuntil the desired temperature is shown in thetemperature display. The temperature will change by2°F (or 1°C) with each press. See below.Fahrenheit : -2°F ➞ -4°F ➞ -6°F ➞ -8°F ➞ 8°F ➞ 6°F➞ 4°F ➞ 2°F ➞ 0°F ➞ -2°F.Centigrade : -19°C ➞ -20°C ➞ -21°C ➞ -22°C ➞-14°C ➞ -15°C ➞ -16°C ➞ -17°C ➞ -18°C ➞ -19°C.Keep in mind that foods like ice cream may meltat 4°F (or 0°C). The temperature display will movesequentially from -8°F to 8°F (or from -22°C to -14°C).• The locked symbol should be lined up with theindicator line.5. Touch the "Alarm/hold 3 secfor Filter Reset" button( (Filter Reset) ) for about 3 seconds toreset the water filter. The color ofindicator ( ) changes from redto blue, green, or yellow.6. If you turned off the water supply, turn it back on.For a replacement water filter, you can visit yourlocal home Improvement center or contactthe Samsung Parts distributor. Be sure thereplacement water filter has the SAMSUNG logo onthe box and on the water filter.Link : http://www.samsungparts.comRemoving any residual matter inside thewater supply line after installing the waterfilter.1. Turn ON the main water supply and supply waterfrom water supply line.2. Run water through the dispenser until the waterruns clear (approx. 6 to 7 minutes). This will cleanthe water supply system and remove air from thelines.3. Additional flushing may berequired in some households.4. Open the Refrigerator door andmake sure there are no waterleaks coming from the waterfilter.Be sure to flush the dispenser thoroughly,otherwise water may drip from the dispenser.This means that there is still air in the line.Reverse Osmosis Water Supply IMPORTANT:The pressure of the water supply coming out of areverse osmosis system going to the water inlet valveof the refrigerator needs to be between 35 and 120psi (241 and 827 kPa).If a reverse osmosis water filtration system isconnected to your cold water supply, the waterpressure to the reverse osmosis system needs to be a4