English - 10Removing the freezer doorA few things to mention first.• Make sure that you lift the door straight up sothe hinges are not bent or broken.• Be careful not to pinch the water tubing andwire harness on the door.• Place doors on a protected surface to preventscratching or damage.1. Remove a screw on the upper hinge cover( 1 ). With the door open, disengage the twolocking tabs with a flat-head screw driver ( 2 )and remove it while the lifting up the rear of thecover ( 3 ), and then disconnect the wires bygently pulling them apart ( 4 ).43212. Removing the FIXER HINGE ,and next take offthe upper hinge.Be careful that the door does not fall on you asyou are removing it.Be sure to keep track of all parts you areremoving.3. Next, remove the door from the lower hinge( 5 ) by carefully lifting the door straight up ( 6 ).65Be careful not to pinch the water tubingand wire harness on the door.Reattaching the freezer doorsTo reattach the freezer doors, replace parts inreverse order.Reattaching the Water Supply Line1. The Water Line must be fully Inserted to thecenter of transparent coupler to prevent waterleakage from the dispenser.2. Insert the 2 clips in the install pack and checkthat each clip holds the line firmly.Center of transparent couplerClip A (¼”) (6.35 mm)Do not cut the water line.Gently separate it from the coupler.DA68-02500B-13.indb 10 13. 12. 4. �� 7:12