Samsung RSG309 series User Manual

Also see for RSG309 SERIES: Quick start guide User manual User manual User manual

English - 0901 SETTING UPWhen moving your refrigeratorTo prevent floor damage, be sure the front levellinglegs are in the up position (above the floor).Refer to ‘Levelling the refrigerator’ in this manual(page 11).To protect the finish of your flooring while you areinstalling the refrigerator, place a large section ofthe cardboard carton under the refrigerator whereyou are working.Leg Screw DriverWhen installing, servicing or cleaningbehind the refrigerator, be sure to pull theunit straight out and push back straight inafter finishing.SETTING UP THE REFRIGERATORNow that you have your new Refrigerator installedin place, you are ready to set up and enjoy thefeatures and functions of the appliance.By completing the following steps, yourRefrigerator should be fully operational.If not, first check the power supply and electricitysource or try the troubleshooting section at theback of this user’s guide.If you have any further questions, contact yourSamsung Electronics service center.1. Place the Refrigerator in an appropriate locationwith reasonable clearance between the walland the Refrigerator.Refer to installation instructions in this manual.CAUTION2. Once the Refrigerator is plugged in, make surethe interior light comes on when you open thedoors.3. Set the Temperature control to the coldesttemperature and wait for an hour.The Freezer will get slightly chilled and themotor will run smoothly.4. After powering the Refrigerator, it will take a fewhours to reach the appropriate temperature.You can store food and drinks in theRefrigerator after the temperature is sufficientlycool.SETTING UP THE REFRIGERATORDOORSIf your entrance won’t allow the refrigerator to passeasily through it, you can remove the doors.Separating the Water Supply Line fromthe Refrigerator1. Pull the two water lines (which are in the Fixer)out to the front.2. Remove two water lines (White one is for waterand the other one is for ice) by pressing thecoupler ( 1 ) and pulling the water line ( 2 )away.12Make sure the color of the water linesmatch.DA68-02500B-13.indb 9 13. 12. 4. �� 7:12