English - 11SETTING UPREMOVING THE REFRIGERATORDOORSFor some installations, you need to remove thefridge and freezer drawers so you can move therefrigerator to its final location.Do not remove the doors/drawer if you don’t needto. If you do not need to remove the refrigeratordoors, go to ‘Leveling the Refrigerator’ on page14.If you need to remove the doors. continue below.Before removing the door/drawer, make sure youread the following items:WARNINGDisconnect power to the refrigerator beforeremoving the door or drawer.• Be careful not to drop, damage orscratch the door / drawer while removingthem.• Be careful not to injure yourself while removingthe doors / drawer.• Reattach the door/drawer properly to avoid:- Moisture from air leakage.- Uneven door alignment.- Wasting energy due to improper door seal.WARNINGDisassembling the refrigerator doorsBe careful not to drop and scratch the doors whileremoving them.With the door opened1. Remove 3 screws holding down the TOPTABLE ( 1 ) and separate the connected wires.(1)2. Disconnect two connectors ( 2 ) on the left sidedoor. To remove the water coupler from thehinge, twist and pull it from the hinge.Remove the water line ( 3 ) while pressing themarked part ( 4 ) of the water line coupler.(2)(3)(4)Red Clip(1/4")CAUTIONIf a red clip is on the coupler, you must remove itbefore removing the tube.3. Pull and remove the hinge lever ( 5 ).Remove the ground screw ( 6 ) attached to theupper left door hinges with a philips screwdriver(+). Remove the upper left and right doorhinges ( 7 ).(5)(7)(6)DA68-03029A-01.indb 11 2014. 3. 19. �� 9:24