English - 15SETTING UP1. Pull out the freezer drawer ( 1 ) to reveal thelower hinge ( 2 ).2. Insert the supplied allen wrench (5/32” (4 mm))( 3 ) into the shaft ( 4 ) of the lower hinge.3. Adjust the height by turning the hex wrench( 3 ) clockwise ( DOWN ) or counter clockwise( UP ).(3)(1)(3)(2)(4)When you turn the hex wrench counter-clockwise ( ), the door will move up.4. After adjusting the doors, insert the suppliedfastener ( 6 ) using a pliers ( 5 ) in the gapbetween the hinge-grommet ( 7 ) and the lowerhinge ( 8 ).The number of fasteners you’ll need to insertdepends on the gap.2 fastener are enclosed with therefrigerator.The thickness of each fastener is 0.04”.WARNING• Keep the fasteners used to level the refrigeratordoors out of the reach of children.Do not let children play with them.- There is a risk of death from suffocation if achild swallows a fastener.MAKING MINOR ADJUSTMENTSBETWEEN OUT DOOR AND INDOORAfter raising the out door, insert the supplied SHIMHINGE MIDDLE in the gap between the OUTDOOR and the HINGE-SHAFT.SHIM HINGE MIDDLE are enclosed withthe refrigerator.The thickness of RING is 0.04” (1 mm).CAUTIONKeep the Rings out of the reach of children andmake sure that children do not play with them orput them into their mouths.DA68-03029A-01.indb 15 2014. 3. 19. �� 9:24