Samsung SCC-C6405(P) Owner's Instructions Manual

Also see for SCC-C6405: Owner's instructions Owner's instructions

3-8EEXITThe EXIT menu is used to quit the CAMERA SET menu of theSCC-C6405(P) and return to the MAIN MENU.- QUIT : Ignores the changed information and restores the savedinformation.- SAVE : Saves the information of the setting condition of the menu.- PRESET : Ignores the changed information and restores the initialfactory defaults of the menu.(CAMERA SET)CAMERA ID OFFV-SYNC INTCOLOR/BW BW...MOTION DET OFFZOOM SPEED 3DIGITAL ZOOM OFFEXIT QUIT(CAMERA SET)CAMERA ID OFFV-SYNC INTCOLOR/BW BW...MOTION DET OFFZOOM SPEED 3DIGITAL ZOOM X10EXIT QUITDIGITAL ZOOMYou may set up the digital zoom magnification ratio in the DIGITAL ZOOMmenu. The magnification ratio ranges from OFF to 10. If you set DigitalZoom of SCC-C6405(P) to max. 10 times, the mode will become the 22 timeoptical zoom and you will be able to enlarge a subject by max. 220 times.Use Left or Right to select a magnification ratio in the DIGITAL ZOOM menu.ZOOM SPEEDIn the ZOOM SPEED menu you can select the speed of the ZOOM Key(Tele/Wide).Use the [Left] or [Right] keys in the ZOOM SPEED menu to selectthe speed.1 : Slowest speed2 : Low speed3 : High speed4 : Fastest speed3-7Select ON and press [ENTER] and the MOTION DET additional menu willappear. The AREA menu, selecting the screen area where the MOTIONdetection function will be applied may be selected by PRESET or USER.Set AREA to PRESET and the MOTION detection function will be applied tothe factory default part.If you set the AREA menu to USER and press [ENTER], you may vary the sizeand position of the area where you want to apply the MOTION detectionfunction by yourself. Press Left, Right, Up, or Down to select an area size.Press ENTER and then Left, Right, Up, or Down to select a position. PressENTER again to move back to the upper menu.Use [ENTER] and Left, Right, Up, or Down to move and scale the MOTIONdetection area.Press [ENTER] again and you will escape the AREA setup menu.Use SENSITIVITY to set up the sensitivity of MOTION detection strength.The higher, the more sensitive.➜Press[Enter]MOTION DETIn MOTION DET, you can set the Motion Detection function, Motion DetectionSensitivity, and the Area of Motion Detection. If the Motion Detection functionis set, the movement of an intruder can be detected. When motion is detected,it sets off the Alarm signal of the Controller.(CAMERA SET)CAMERA ID OFFV-SYNC INTCOLOR/BW COLORMOTION DET ON...ZOOM SPEED 3DIGITAL ZOOM OFFEXIT QUIT(MOTION DET)AREA PRESET...SENSITIVITY L ---|--- HRET➜Use the [Left,Right, Up, Down]KeysSIZEPOSITIONSIZEPOSITIONAfter PAN/TILT movement finishes, MOTION DET function will not workfor about 5 seconds to stablize the chage of the screen.* MOTION detection function operates based on the brightness changewithin the setup region. Therefore, erroneous operation may occurdepending on the brightness difference between the background andthe object that is being taken, or the status of the area setup, etc.