Wireless network setup1862. Using a Network-Connected MachineConnecting Failure - Invalid Security• Security is not configured correctly. Check the configured security on youraccess point and machine.Connecting Failure - General Connection Error• Your computer is not receiving a signal from your machine. Check the USBcable and your machine’s power.Connecting Failure - Connected Wired Network• Your machine is connected with a wired network cable. Remove the wirednetwork cable from your machine.PC Connection Error• The configured network address is unable to connect between yourcomputer and machine.- For a DHCP network environmentThe receives the IP address automatically (DHCP) when computer isconfigured to DHCP.- For a Static network environmentThe machine uses the static address when the computer is configuredto static address.For example,If the computer’s network information is as shown below:▪ IP address: 169.254.133.42▪ Subnet Mask: 255.255.0.0Then the machine’s network information should be as below:▪ IP address: 169.254.133.43▪ Subnet Mask: 255.255.0.0 (Use the computer’s subnet mask.)▪ Gateway: 169.254.133.1Other problemsIf problems occur while using the machine on a network, check the following:For information on the access point (or wireless router), refer to its ownuser's guide.• Your computer, access point (or wireless router), or machine may not beturned on.• Check the wireless reception around the machine. If the router is far fromthe machine or there is an obstacle, you might have difficulty receiving thesignal.• Cycle the power for the access point (or wireless router), machine, andcomputer. Sometimes cycling the power can recover networkcommunication.
