Troubleshooting_ 93• Do not mix paper types in a tray.• Use only recommended print media (See "Setting the paper size andtype" on page 50).• Ensure that the recommended side of the print media is facing down inthe tray, or facing up in the manual tray.CLEARING PAPER JAMSWhen a paper jam occurs, a warning message appears on the display.To resume printing after clearing paper jams, you must open and close thefront door.To avoid tearing the paper, pull the jammed paper out slowly andgently. Follow the instructions in the following sections to clear thejam.In tray 1Click this link to open an animation about clearing a jam.1. Open and close the front door. The jammed paper is automaticallyejected from the machine.If the paper does not exit, go to the next step.2. Pull out tray 1 .3. Remove the jammed paper by gently pulling it straight out.If the paper does not move when you pull, or if you do not see the paperin this area, check the fuser area around the toner cartridge (See "Insidethe machine" on page 93).4. Insert tray 1 back into the machine until it snaps into place. Printingautomatically resumes.In the manual trayClick this link to open an animation about clearing a jam.1. If the paper is not feeding properly, pull the paper out of the machine.2. Open and close the front door to resume printing.Inside the machineClick this link to open an animation about clearing a jam.The fuser area is hot. Take care when removing paper from themachine.1. Open the front door and pull the toner cartridge out, lightly pushing itdown.
