Section 2: Understanding Your Phone2A: Your PCS Phone - The Basics 24Turning Your Phone ON and OFFTurning Your Phone ONPress for a few seconds. The phone will display “Powering On”until it locates a signal, then it will automatically enter Standby mode— the phone’s idle state. At this point, you’re ready to begin making andreceiving calls.If your phone is unable to find a signal after 15 minutes of searching, aPower Save feature is automatically activated. When a signal is found,your phone automatically returns to Standby mode.In Power Save mode, your phone searches for a signal periodicallywithout your intervention. You can also initiate a search forPCS Service by pressing any key (when your phone is turned ON).Tip: The Power Save feature helps to conserve your battery power whenyou are in an area where there is no signal.Turning Your Phone OFFPress for a few seconds until you see “Powering off...” on thedisplay screen.Adjusting the Brightness1. To adjust the brightness from the PDA menu, tap the brightness iconlocated in the upper right corner of the alpha Graffiti writingarea.2. Use the slider to adjust the desired brightness level. Tap Done to saveand exit.
