Connecting an Amplifier/DVD Home TheaterAmplifier/DVD Home Theater TV Rear Panel@@eeEAudio Cable (Not supplied)>_ Each external input source device has a different back panel configuration.>_ When connecting an external device, match the color of the connection terminal to the cable.1= Connect Audio Cablesbetween the AV OUT [L-AUDIO-R] on the TV andAUDIO IN on theAmplifier/DVD HomeTheater.When an audio amplifieris connected to the"AUDIO OUT [L-AUDIO-R]" terminals: Decreasethe gain (volume) of theTV, and adjust thevolume level with theAmplifier's volumecontrol.OperationTurning the TV On and OffPOWERSOURCEPress the POWER button on the remote control.You can also use the POWER button on the TV.Plug & Play FeatureWhen the TV is initially powered on, basic customer settings proceed automatically and subsequently:1, Press the POWER button on the remote control.The message "Menu language, Channels and Time will be set." is displayed.Press the ENTER button, then "Select the language of the OSD." menu isautomatically displayed.2, Press the ENTER button to enter the language.Press the • or • button to select language, then press the ENTER button."Select the antennas to memorize." menu is automatically displayed.3= Press the • or • button to memorize the channels of the selected connection.Press the ENTER button to select "Start".>_ If the antenna is connected to ANT 1 (AIR), select "Air" and if it is connected to ANT 2(CABLE), select "Cable".>_ If both ANT 1 (AIR) and ANT 2 (CABLE) are connected, select the "Air + Cable".>_ In Cable mode, you can select the correct signal source among "STD", "HRC", and"IRC" by pressing the • button, then press the • or • button.Press the I_ button to select "Start", then press the ENTER button.Contact your local cable company to identify the type of cable system that exists in yourparticular area.Continued...English- 13