POWERAUTO PROG ADD/DEL MTS SRS_ sE_ O r_ESET_JIMSUNGSetting Up the Remote control to Operate Your DVD1. Turn off your DVD.2. Press the DVD button on your TV's remote control.3. Press the SET button on your TV's remote control.4. Using the number buttons on your remote control, enter three digits of the DVDcode listed on page 22 of this manual for your brand of DVD. Make sure youenter three digits of the code, even if the first digit is a "0". (If more than onecode is listed, try the first one.)5. Press the POWER button on the remote control.Your DVD should turn on if your remote control is set up correctly.If your DVD does not turn on after set-up, repeat steps 2, 3 and 4, but try one ofthe other codes listed for your brand of DVD. If no other codes are listed, tryeach code, 000 through 141.Note on Using Remote Control Modes: DVDWhen your remote control is in "DVD" mode, the volume buttons still control yourTV's volume.AUTO PROG ADD/DEI MTS SRS_AMSUNGSettinu_DUUthe Remote control to Operate Your Set _ Box1. Turn off your STB.2. Press the STB button on your TV's remote control.3. Press the SET button on your TV's remote control.4. Using the number buttons on your remote control, enter three digits of the STBcode listed on page 21 of this manual for your brand of STB. Make sure youenter three digits of the code, even if the first digit is a "0". (If more than onecode is listed, try the first one.)5. Press the POWER button on the remote control.Your STB should turn on if your remote control is set up correctly.If your STB does not turn on after set-up, repeat steps 2, 3 and 4, but try one ofthe other codes listed for your brand of STB. If no other codes are listed, tryeach code, 000 through 074.Note on Using Remote Control Modes: STBWhen your remote control is in "STB" mode, the volume buttons still control your TV'svolume.English- 19Continued...