Samsung TX-S3082WH Owner's Instructions Manual

Also see for TX-R3079WH: Manual Owner's instructions Owner's instructions Owner's instructions Owner's instructions

Contents

Memorizing the ChannelsYour TV can memorize and store all of the available channels tk_rboth "off' air" (air) and cable channels.After the available channels are memorized, use the CH A or CH V button to scan through the channels.This eliminates the need to change channels by entering the channel digits. There are three steps tbr memorizing channels:selecting a broadcast source, memorizing the channels (amomatic) and adding and deleting channels (manual).Selecting the Video Signal-sourceBefore your television can begin memorizing the available channels, you must specify the type of signal source that is connected to theTV (i.e. an air or a cable system).1. Press the MENU button to display the menu.Press the • or • button to select "Channel", then press the ENTER button.2. Press the ENTER button select "Antenna".Press the • or • button to select "Air" or "Cable", then press the ENTERbutton.Press the EXIT button to exit.Storing Channels in Memory (Automatic Method)1. Press the MENU button to display the menu.Press the • or • button to select "Channel", then press the ENTER button.2. Press the • or • button to select "Auto Program", then press the ENTERbutton.3. Press the • or • button to select the antenna connection, then press theENTER button.> Air: 'Air" antenna signal.Cable: 'Cable" antenna signal.Air+Cable: 'Air" and 'Cable" antenna signals.If the antenna is connected to ANT 1 IN (AIR), select 'Air" and if it is connected to ANT2 IN (CABLE), select 'Cable".If both ANT 1 IN and ANT 2 IN are connected, select the 'Air + Cable".If you selected 'Air", then go to step 5.4. Select the correct signal source (STD, HRC, and IRC) by pressing the 4 button,then press the • or • button.Press the _- button to select "Start", then press the ENTER button.STD, HRC, and IRC identify various types of cable TV systems. Contact your localcable company to identify the type of cable system that exists in your particular area. Atthis point the signal source has been selected.5. After all the available channels are stored, the "Auto Program" menu reappears.Press the EXIT button to exit.AUTO PROG ADD/DEL MTS SRSYou can also press the AUTO PROG. button on the remote control to bring up theAuto Program menu.English- 17