Samsung TX-S3082WH Owner's Instructions Manual

Also see for TX-R3079WH: Manual Owner's instructions Owner's instructions Owner's instructions Owner's instructions

Contents

Installing Batteries in the Remote Control1, Lift the cover at the back of the remote control upward as shown in the figure.2, Install two AAA size batteries.>_ Make sure to match the %" and "-" ends of the batteries with the diagram inside the compartment.3, Replace the cover.>_ Remove the batteries and store them in a cool, dry place if you won't be using the remote control for a long time.The remote control can be used up to about 23 feet from the TV.(Assuming typical TV usage, the batteries last for about one year.)If the remote control doesn't work, check the following:1. Is the TV power on?2. Are the plus and minus ends of the batteries reversed?3. Are the batteries drained?4. Is there a power outage, or is the power cord unplugged?5. Is there a special fluorescent light or neon sign nearby?ConnectionsConnecting VHF and UHF Antennas, , , If' your antenna has a set of leads that look like this, see "Antennas with 300 _ Flat Twin Leads") ( below.pIf your antenna has one lead that looks like this, see "Antennas with 75 _ Round Leads".If you have two antennas, see "Separate VHF and UHF Antennas".Antennas with 300 _ Flat Twin LeadsIf you are using an offair antenna such as a roof antenna or "rabbit ears") that has 300 _Qtwin fiat leads, tk)llow the directions below.1, Place the wires from the twin leads under the screws on a 300-75 _ adapter (notsupplied).Use a screwdriver to tighten the screws.2, Plug the adaptor into the ANT 1 IN (AIR) terminal on the back of the TV.Antennas with 75 _ Round Leads1. Plug the antenna lead into the ANT 1 IN (AIR) terminal on the back of the TV.Separate VHF and UHF AntennasIf you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals beti)re connectingthe antennas to the TV. This procednre requires an optional combiner adaptor (available at most electronics shops).1. Connect both antenna leads to the combiner............. u.F ,_2, Plug the combiner into the ANT 1 IN (AIR) terminal on the back of the T>English-8