Samsung UE40B7020 User Manual

Also see for UE40B7000WW: Service manual

Contents

English Anynet+Troubleshooting for Anynet+Problem Possible SolutionAnynet+ does not work. Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+ devicesonly.Connect only one receiver (home theatre).Check if the Anynet+ device power cord is properly connected.Check the Anynet+ device’s Video/Audio/HDMI 1.3 cable connections.Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.Check whether the TV remote control is in TV mode.Check whether it is Anynet+ exclusive remote control.Anynet+ doesn’t work in certain situations. (Searching channels, Operating Media Play,Plug & Play, etc.)When connecting or removing the HDMI 1.3 cable, please make sure to search devicesagain or turn your TV off and on again.Check if the Anynet+ Function of Anynet+ device is set on.●●●●●●●●●●I want to start Anynet+. Check if the Anynet+ device is properly connected to the TV and check if the Anynet+(HDMI-CEC) is set to On in the Anynet+ Setup menu.Press the TV button on the TV remote control to switch to TV. Then press the TOOLS buttonto show the Anynet+ menu and select a menu you want.●●I want to exit Anynet+. Select View TV in the Anynet+ menu.Press the SOURCE button on the TV remote control and select a device other than Anynet+devices.Press P >/<, PRE-CH, and FAV.CH to change the TV mode. (Note that the channelbutton operates only when a tuner-embedded Anynet+ device is not connected.)●●●The message ‘Connecting toAnynet+ device...’ appears onthe screen.You cannot use the remote control when you are configuring Anynet+ or switching to a viewmode.Use the remote control when the Anynet+ setting or switching to view mode is complete.●●The Anynet+ device does notplay.You cannot use the play function when Plug & Play is in progress.●The connected device is notdisplayed.Check whether or not the device supports Anynet+ functions.Check whether or not the HDMI 1.3 cable is properly connected.Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.Search Anynet+ devices again.You can connect an Anynet+ device using the HDMI 1.3 cable only. Some HDMI cables maynot support Anynet+ functions.If it is terminated by an abnormal situation such as disconnecting the HDMI cable or powercord or a power failure, please repeat the device scan.●●●●●●The TV programme cannot berecorded.Check whether the antenna jack on the recording device is properly connected.●The TV sound is not outputthrough the receiver.Connect the optical cable between TV and the receiver.●