Samsung UN40N5200AF E-manual

Also see for UN40N5200AFXZA: E-manual

- 99 -Anynet+ (HDMI-CEC) Isn't WorkingWhen Anynet+ (HDMI-CEC) isn't working, these steps may help resolve the problem.The problem Try this!Anynet+ does not work.Confirm that the device is an Anynet+ device. The Anynet+ system supports Anynet+ devicesonly.Check if the power cord of the Anynet+ device is properly connected.Check the cable connections of the Anynet+ device.Go to Anynet+ (HDMI-CEC) and see if Anynet+ (HDMI-CEC) has been set to On.● Settings General External Device Manager Anynet+ (HDMI-CEC)Anynet+ may not function when some other functions are active, including Channel Search,Smart Hub, Initial Setup, etc.If you have disconnected and then reconnected the HDMI cable, scan for devices again or turnyour TV off and on.I want to start Anynet+.Move the focus to the Anynet+ device at Source, and then press the up directionalbutton.Check if the Anynet+ device is properly connected to the TV, and then select Anynet+ (HDMI-CEC) menu to see if Anynet+ (HDMI-CEC) is set to On.● Settings General External Device Manager Anynet+ (HDMI-CEC)I want to exit Anynet+. Set Anynet+ (HDMI-CEC) to Off.● Settings General External Device Manager Anynet+ (HDMI-CEC)The message "Connectingto Anynet+ device..." or"Disconnecting fromAnynet+ device" appearson the screen.You cannot use the remote control when the TV is configuring Anynet+ or switching to aviewing mode. Use the remote control after the TV has completed the Anynet+ configuration orhas switched to a viewing mode.The Anynet+ device won'tplay. You cannot use the play function when Start Setup is in progress.